Seat Occupancy Mat Bypass BMW 7 Series E66 E67 Passenger Driver Sensor Emulator

Seat Occupancy Mat Sensor Emulator for BMW 7-SERIES

- for BMW variants with 2 wire seat mat plug

Common Faults appear on your iDrive and you wish to remove them?

• Passenger Restraint System
• Front Pass. Restraint System Fault
• Driver Restraint System Malfunction
• Restraint Sys. Malfunction/Defective
• Fault in Pass. Restraint System Affecting Airbag

Seat Occupancy Mat Emulator is designed as a quality alternative to bypass faulty seat occupancy mat/pad sensor and turn off the airbag light. It completely simulates the passenger in the seat and re-activates the airbag system making it deploy in case of an accident, therefore, allowing to pass a car test.

Seat Belt Simulator/Bypass (if applicable) is designed to bypass safety belt warning light/alarm which occurs after fitting Seat Mat Emulator as the seat becomes always occupied. Applies to vehicles with factory installed seat belt warning. 

After fitting our device seat becomes Always Occupied - Occupied Person.

package contents:

1 x Seat Occupancy Mat Sensor Emulator (Bypass) for 65778367242

Compatibility Pre-Check

• With ignition off move the passenger/driver seat all the way up and lean the seat forward or backwards to gain good access.
• From the rear under the seat locate usually black colour control unit box. Locate seat occupancy mat plug with white & blue wires connected to it as in picture below.

NOTE: For US spec 7 Series manufactured between 2004 and 2007 older or newer type device might be compatible. Also, compatibility for passenger and driver seats usually is different so checking compatibility yourself before purchase is necessary to avoid any disappointments later on.

For some variants control unit may be hidden under the seat cushions. If you can't locate it then please contact us by eBay message and specify the Last 7 Digits of car Chassis, VIN (Vehicle Identification Number) and we will check the compatibility for you.

(Seat Control Unit Box with Seat Occupancy Mat Plug)

Before installing emulator(s) it is necessary to check that:

• the Airbag Light is ON because of a faulty seat occupancy mat
• Car battery is in fairly new or in good condition & fully charged
• Car ECU (brain) is free of other airbag light related faults/errors as - belt tensioner/seat belt wires (located under the seatbelt buckle), driver’s/passenger’s airbags, safety battery terminal, airbag control module, etc. as those faults/errors can prevent our device from working properly. In such case please contact and provide those fault/error codes for further assistance.

After installing seat occupancy mat emulator and if applicable seatbelt simulator/bypass if lights (faults) won't reset automatically it has to be reset with diagnostics software. Only then the lights will be off.